Machinability parameters of single-tooth  and multi-tooth face milling

Pavel Kovač

doi:10.24867/JPE-1994-11-043

Vol. 11 No. 1, 2 (1994): Journal of production engineering

Original Research Article

Machinability parameters of single-tooth and multi-tooth face milling

FULL TEXT ARTICLE (PDF)

Pavel Kovač

more info

Pavel Kovač
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia

DOI: https://doi.org/10.24867/JPE-1994-11-043

Published 1994-12-01

abstract views: 3 // FULL TEXT ARTICLE (PDF): 3

Keywords

tool life,
surface roughness,
cutting forces,
cutting temperature

How to Cite

Kovač, P. (1994). Machinability parameters of single-tooth and multi-tooth face milling. Journal of Production Engineering, 11(1, 2), 43–55. https://doi.org/10.24867/JPE-1994-11-043

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

Because of the higher amount of material waste, most tool life tests in the face milling process are done with a single-tooth tool and the results are used for mufti-tooth tool life prediction. The total tool life of a multi-tooth cutter by multiplying the values of tool life of a single tooth cutter by number of teeth, is obtained But there the phenomenon of tool life reduction in the case of multi-tooth cutter in comparison with single tooth cutter , during constant cutting conditions was observed. The later experimental investigations carried out in milling showed that the phenomenon of run-out of the cutting edges in milling cutter yield influence on the tool life of cutter, surface roughness, cutting forces and cutting temperature.

PlumX Metrics

Dimensions Citation Metrics