Journal of Production Engineering

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 10 No. 10 (1993): Former "Proceedings of the Institute of Production Engineering"
Original Research Article

A proposition for a clasification model of electrodes for resistance spot welding

FULL TEXT ARTICLE (PDF)
  • Lazar Brestovački,
  • Sabo Bela,
  • Jovica Dakić
Lazar Brestovački
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Sabo Bela
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Jovica Dakić
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
DOI: https://doi.org/10.24867/JPE-1993-10-001

Published 1993-12-01

abstract views: 9 // FULL TEXT ARTICLE (PDF): 6


Keywords

  • model of electrodes,
  • welding,
  • production

How to Cite

Brestovački, L., Bela, S., & Dakić, J. (1993). A proposition for a clasification model of electrodes for resistance spot welding. Journal of Production Engineering, 10(10), 1–12. https://doi.org/10.24867/JPE-1993-10-001

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

A classification model of electrodes for resistance spot welding takes into account all the information about electrodes required for a complete definition: the material, the method of production, the shape of the electrode part for positioning and clamping, the forms of the electrode tip, the contours of the electrode, the cooling system of the electrode tip, the cross-sectional shape of the electrode, the maximum dimensions of electrode face shapes, and the dimensions of the cross section of the electrode. This paper is based on existing national standards, German (DIN) and Yugoslav (JUS), recommendations from other technical literature, and practical experience. A proposed model of classification could be applied during the design phase as well as during the execution of resistance spot welding.

PlumX Metrics

Dimensions Citation Metrics

FULL TEXT ARTICLE (PDF)