Journal of Production Engineering

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 6 No. 5, 6 (1989): Former "Proceedings of the Institute of Production Engineering"
Original Research Article

Contribution to research after foundations for defining the conception of machining system modular design

FULL TEXT ARTICLE (PDF)
  • Jožef Rekecki,
  • Milan Zeljković,
  • Ljubomir Borojev,
  • Ratko Gatalo,
  • Janko Hodolič
Jožef Rekecki
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Milan Zeljković
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Ljubomir Borojev
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Ratko Gatalo
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Janko Hodolič
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
DOI: https://doi.org/10.24867/JPE-1989-06-109

Published 1989-12-01

abstract views: 6 // FULL TEXT ARTICLE (PDF): 3


Keywords

  • turning,
  • grinders,
  • drilling,
  • machining centers,
  • construction

How to Cite

Rekecki, J., Zeljković, M., Borojev, L., Gatalo, R., & Hodolič, J. (1989). Contribution to research after foundations for defining the conception of machining system modular design. Journal of Production Engineering, 6(5, 6), 109–128. https://doi.org/10.24867/JPE-1989-06-109

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

The paper presents some results of research into the geometric and technological characteristics in the late construction of turning machines, grinders, drilling machines, and machining centers. This research forms the foundation for designing their primary characteristics and defining the concept of modular design. Despite this, the initial approach was that one of the most efficient methods for forecasting the technical characteristics of machining systems is trend extrapolation.

PlumX Metrics

Dimensions Citation Metrics

FULL TEXT ARTICLE (PDF)