Journal of Production Engineering

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 3 No. 3 (1986): Former "Proceedings of the Institute of Production Engineering"
Original Research Article

The development of the system for automatic design of rotational parts

FULL TEXT ARTICLE (PDF)
  • Ratko Gatalo,
  • Slobodan Navalušić
Ratko Gatalo
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Slobodan Navalušić
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
DOI: https://doi.org/10.24867/JPE-1986-03-001

Published 1986-09-01

abstract views: 64 // FULL TEXT ARTICLE (PDF): 3


Keywords

  • design,
  • rotational parts

How to Cite

Gatalo, R., & Navalušić, S. (1986). The development of the system for automatic design of rotational parts. Journal of Production Engineering, 3(3), 1–14. https://doi.org/10.24867/JPE-1986-03-001

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

The paper deals with a system for automatic design of rotational parts with technical drawing as an exit. Only basic informations have been presented about modules of the sys­tem processor. Particulary are presented informations about testing results obtained on computer. EI-H6/43 and graphic terminal TEKTRONIX 4010. The paper presents a part of the results of the several years research project at the Institute for Production Engi­neering of Faculty of Technical Sciences in Novi Sad.

PlumX Metrics

Dimensions Citation Metrics

FULL TEXT ARTICLE (PDF)

Similar Articles

You may also start an advanced similarity search for this article.