Determination of the roughness after polishing using fractional design in the responce surface methodology

Pavel Kovač; Jelena Stankov

doi:10.24867/JPE-1984-01-217

Vol. 1, No. 1 (1984) (Former "Proceedings of the Institute of Production Engineering")

Original Research Article

Determination of the roughness after polishing using fractional design in the responce surface methodology

FULL TEXT ARTICLE (pdf)

Pavel Kovač,
Jelena Stankov

more info

Pavel Kovač University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia

Jelena Stankov University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia

Published 1984-09-15

Keywords

responce surface methodology,
fractional design

Abstract

In this article special steel for medical equipment 4590 was considered, using response surface methodology. This procedure is applied to determine the surface roughness after turning and polishing operations.

FULL TEXT ARTICLE (pdf)