Journal of Production Engineering

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 1, No. 1 (1984) (Former "Proceedings of the Institute of Production Engineering")
Original Research Article

Exploring response surface of cutting forces for an end milling cutter

FULL TEXT ARTICLE (PDF)
  • Pavel Kovač
Pavel Kovač
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
DOI: https://doi.org/10.24867/JPE-1984-01-073

Published 1984-12-12

abstract views: 4 // FULL TEXT ARTICLE (PDF): 4


Keywords

  • milling,
  • cutting force,
  • feed,
  • depth of cut,
  • cutting speed

How to Cite

Kovač, P. (1984). Exploring response surface of cutting forces for an end milling cutter. Journal of Production Engineering, 1(1), 73–84. https://doi.org/10.24867/JPE-1984-01-073

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

This paper deals with the fundamental determina­tion of cutting forces in face milling, describes the measure equipment and computer use Some results including the variation of cutting forces with feed, speed and depth of cut are presented.

PlumX Metrics

Dimensions Citation Metrics

FULL TEXT ARTICLE (PDF)