Journal of Production Engineering

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 21 No. 1 (2018)
Original Research Article

Wear of model and integral face milling cutter modelled by artificial intelligence

FULL TEXT ARTICLE (PDF)
  • Pavel Kovač,
  • Borislav Savkovic,
  • Dragan Rodić,
  • Marin Gostimirović,
  • Ildiko Mankova
Pavel Kovač
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Borislav Savkovic
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Dragan Rodić
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Marin Gostimirović
University of Novi Sad, Faculty of Technical Sciences, Departman for Production Engineering, Trg Dositeja Obradovica 6, 21000 Novi Sad, Serbia
Ildiko Mankova
Technical University of Košice, Faculty of Mechanical Engineering, Deptartment of Manufacturing Technology and Materials, Mäsiarska 74, 040 01 Košice.
DOI: https://doi.org/10.24867/JPE-2018-01-011

Published 2023-11-26

abstract views: 10 // FULL TEXT ARTICLE (PDF): 5


Keywords

  • Wear parameters,
  • face milling,
  • modelling,
  • neural network

How to Cite

Kovač, P., Savkovic, B., Rodić, D., Gostimirović, M., & Mankova, I. (2023). Wear of model and integral face milling cutter modelled by artificial intelligence. Journal of Production Engineering, 21(1), 11–16. https://doi.org/10.24867/JPE-2018-01-011

Copyright (c) 2023 Journal of Production Engineering

Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

The paper presents results of experimental study of model single tooth and integral multi tooth milling cutter. During the study research were tool wear on rake face and flank face of face milling cutter during processing time. Radial and axial throw of tooth were small and wear parameters are during processing time remain near for both cases. Tool wear of model single tooth and eight teeth face milling cutter were modeled by statistical method and artificial intelligence neural network model and were compared. Better models were achieved with artificial intelligence method.

PlumX Metrics

Dimensions Citation Metrics

FULL TEXT ARTICLE (PDF)