Advanced Technologies and Materials

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut ero labore et dolore magna aliqua. Ut enim ad minim veniam, quis nostrud exercitation ullamco.

Search
GUIDE FOR AUTHORS SUBMIT MANUSCRIPT
Vol. 37 No. 2 (2012): Journal for Technology of Plasticity
Original articles

Atomic force microscopy in metal forming and dental materials characterization

Full text article (PDF)
  • Marko Vilotić,
  • Tijana Lainović,
  • Damir Kakaš,
  • Larisa Blažić,
  • Dubravka Marković,
  • Aljoša Ivanišević
Marko Vilotić University of Novi Sad, Faculty of Technical Sciences, Serbia
Tijana Lainović University of Novi Sad, Faculty of Medicine, School of Dentistry, Serbia
Damir Kakaš University of Novi Sad, Faculty of Technical Sciences, Serbia
Larisa Blažić University of Novi Sad, Faculty of Medicine, School of Dentistry, Serbia; Clinic of Dentistry of Vojvodina, Serbia
Dubravka Marković University of Novi Sad, Faculty of Medicine, School of Dentistry, Serbia; Clinic of Dentistry of Vojvodina, Serbia
Aljoša Ivanišević University of Novi Sad, Faculty of Technical Sciences, Serbia

Published 2012-12-28

Keywords

  • atomic force microscopy,
  • surface roughness,
  • dental nanomaterials,
  • metal forming
Creative Commons License

This work is licensed under a Creative Commons Attribution 4.0 International License.

Abstract

Atomic force microscope has been widely used for surface topography measurement in many scientific areas. In metal forming technology atomic force microscope allows analysis of various tribological phenomenon on die and produced part. Surface topography in dental restorative materials is very important since smoother tooth's surface prevents bacterial biofilm retention which is the main cause of dental pathology. This paper presents results of characterization of upset rings in friction coefficient test andresults of characterization of dental materials.

Full text article (PDF)

Most read articles by the same author(s)

<< < 1 2